DURING INSPECTION, TECHNICIAN NOTED SEVERAL AREAS OF CONCERN. FROM THERE RL CUSTOMER AND TECHNICIAN SPOKE ABOUT CONCERNS. FROM THERE RL PROVIDED CUSTOMER WITH ESTIMATE AND HE APPROVED.
REMOVE AND REPLACE FOG LIGHT
CONTROL ARM – Remove & Replace – DRIVERS SIDE LOWER
MOUNT & BALANCE
PLACE VEHICLE ON ALIGNMENT RACK, ATTACH EQUIPMENT, MEASURE CASTER, CAMBER AND TOE. COMPARE TO VEHICLE SPECIFICATIONS. SET AND ADJUST ALL APPROVED ALIGNMENT ANGLES WITH ALLOWABLE SPECIFICATIONS.
SWITCH DRIVERS SIDE BRAKE HOSE UPRIGHT TO PASS STATE INSPECTION.
FREE Loaner Vehicle
STEPHEN B. gave our service a 5 star review on 9/27/2024
REMOVE WHEEL FROM VEHICLE. REPAIR TIRE. REINSTALL ON VEHICLE.
REMOVE AND REPLACE REAR BRAKE PADS AND ROTORS
VIRGINIA STATE INSPECTION
Technician test drove vehicle and checked for internally stored codes and at this time was not able to notice hesitation when accelerating. Or any stored history codes. Recommend possible test drive with customer, or should hesitation persist, bring vehicle back in. Hesitation could be caused by multiple different systems in the vehicle.
DON G. gave our service a 5 star review on 3/15/2024
DRAW DOWN A/C SYSTEM-RECHARGE SYSTEM TO FULL AS PER FACTORY SPECIFICATIONS. INSTALL DYE TO AID IN FINDING ANY LEAKS.
REMOVED AND REPLACED THERMOSTAT ASSEMBLY
REMOVED AND REPLACED DRIVER UPPER CONTROL ARMS AND LOWER BALL JOINTS
PERFORM BRAKE SYSTEM FLUSH WITH BG BRAKE SERVICE KIT
REMOVE AND REPLACE REAR BRAKE PADS AND ROTORS
REMOVE AND REPLACE FRONT BRAKE PADS AND ROTORS
CUSTOMER NEEDS BACK BY 1PM
PLACE VEHICLE ON ALIGNMENT RACK, ATTACH EQUIPMENT, MEASURE CASTER, CAMBER AND TOE. COMPARE TO VEHICLE SPECIFICATIONS. SET AND ADJUST ALL APPROVED ALIGNMENT ANGLES WITH ALLOWABLE SPECIFICATIONS.
RICK F. gave our service a 5 star review on 11/17/2023
CHECK SHAKING IN 5 + 6TH GEAR WHEN HEADING UP HILL.
LUBE OIL & FILTER WITH MULTI POINT INSPECTION
TIRE ROTATION-FRONT TO BACK
Technician found upon testing that under load there was a misfire in cylinder #2. Technician inspected ignition coil and plug, and the swapped locations to isolate cause of misfire. After moving suspected coil from cylinder #2 to #3 the misfire moved to cylinder #3. Technician recommend replacing known bad ignition coil, and additionally replacing all remaining coils due to likely hood additional coils failing prematurely. Additionally we replaced all spark plugs to mitigate potential future issues. No Charge to Customer.
Technician replaced Crimed band clamp with bolted worm gear hose clamp to attempt to better secure intake hose at turbocharger.
TIMOTHY F. gave our service a 5 star review on 10/5/2023